Valve Series,Cheap Valve,High Quality Valve,High Quality Ball Valve Jiangsu Qiantu Trading Co., Ltd. , https://www.qtprimingpump.com
2. If the production is interrupted, the main drive and heating stop. When the power supply is restored, the barrels must be reheated to the specified temperature and kept warm for a period of time before the extruder can be started.
3. After 500 hours of use of the extruder, there will be iron scraps or other impurities from the gear box. Therefore, the gear should be cleaned and the gearbox oil should be replaced at the same time.
4. If the steering fullness of the meter and the pointer is found, check whether the contact of the edge such as the thermocouple is good.
Second, the daily maintenance of the extruder 1, the material is not allowed to have debris, metal and sand and other hard materials are strictly prohibited to enter the hopper and extruder.
2. When opening the cylinder cover or the exhaust cover, prevent foreign objects from falling into the host.
3, to have enough warm-up time, manual driving before driving should be brisk. Generally, it should be kept at a constant temperature for 2 hours after reaching the process set temperature.
4. The screw can only be started at low speed, and the idle time is no more than 3 minutes.
Daily maintenance and maintenance of the screw machine
First, maintenance common sense 1, the machine should be used after a period of time to do a comprehensive inspection, check the tightness of all screws.