Whether it is during the cold winters or hot summer days, this is a versatile car seat that will suit you best. It has been equipped with both heating and cooling systems so that it provides quality services. Apart from this, it also provides a vibrating massage for a good feeling when driving. Apart from this, the heated car seat is very safe thanks to the overheat protection thermostat system.
It also has up to dive levels of heating areas that will keep the body at the required temperature. It heats faster in just three minutes; hence very efficient. It comes with remote control for easy operation. Seat Heated,Heated Seat In Car,Car Seat Warmer,Heated Seats Car Seats JiLin Province Debang Auto Electric Co.,Ltd. , https://www.dbatelectric.com
In general, the input device, intermediate conversion device, and output device of the carbon dioxide detector are the three basic components of a test system. The key part of the input device is the sensor. The intermediate conversion device is very different depending on the situation. In a simple test system, it may be completely ignored and the sensor output is directly displayed or recorded. In this design, the measurement accuracy is not very high. In order to reduce the cost, only simple debugging circuits are used.
The CO2 detection module senses a different CO2 concentration and generates a 0 to 4 volt change voltage signal, which is transmitted to the input of ICL7107 via the W1 voltage divider for A/D conversion and display. The ICL7660 provides the ICL7107 with a -5 volt operating voltage. In this design, the thousands of display ICL7107 circuit 19 feet do not use air, only with one, ten, one hundred display, while the single-digit LED digital tube a, b, c, d, e, f foot and 50-ohm resistance Connected to the circuit, only 0 bits are displayed in the digital tube position during operation. Due to the requirement of accuracy of 50×10-6 in the greenhouse, the tens digit of this circuit has been shown to be valid.
Carbon dioxide detector can be widely used in the detection and control of carbon dioxide gas in solar greenhouses. It has the characteristics of low cost and reliable performance. It is an ideal detection instrument for agricultural research institutes and farmers.
Carbon Dioxide Detector Design and Effect on Carbon Dioxide Content Monitoring
In order to increase the efficiency of photosynthesis of crops in greenhouses, the application of carbon dioxide gas fertilizer is very necessary. The application of gas fertilizers to increase production is even more effective. However, because different crops require different concentrations of carbon dioxide, it is necessary to monitor the content of greenhouses in order to apply carbon dioxide economically and rationally. At present, the instruments used to detect carbon dioxide in industry and the environment are relatively expensive, and the economic conditions of the majority of farmers are still unsustainable. The following is a preliminary design of the carbon dioxide detector in the solar greenhouse with the objective of economy and practicality.